SmittybiltBOLT ON RECIEVER HITCH - SBJH46

This is a nice hitch and the price is far better than Mopar. But I had to give it four stars for the directions. For a part with 4 bolts I'm not sure why they are so bad. I doubt the frame is different between JL models Here's what I found so hopefully you don't have to. I have 2018 Sahara JL.Step 1: "loosen all 4 nuts". Reality: you need to completely back them out to the point they are ready to come off.Step 2: "Remove bottom bumper Mounting bolts" Reality: I had no such boltStep 3: "If equipped, remove nut plate" Reality: I have a nut plate, but there is no way it's coming offStep 4: "blah blah blah". Reality: Since you didn't remove the nut plate, you MUST reuse the factory bolts you removed. So you'll have 2 bolts left over. Also the bracket must be for an after market 4-plug flat plug. The Mopar wiring harness does not require it.Also FYI the computer had to be reprogrammed to make the Mopar wiring harness work. This was very expensive. I hope you only need a hitch :)

The directions are a little confusing, as I read in the other reviews. Please know that you DON’T have to take the bumper cover off to get this installed on your Jeep. You DO need to have strong fingers though to get the existing plate off! This will not slide over the plate as some said because 2 of the bolt nuts are welded on. Read thru the other reviews, one of them had perfect directions to follow. All in all, so far so good. Using with a bike rack currently.

Very Easy install but the instructions were bad for my 2019 Jeep JLU. Skipped Steps 1-3 and just used the 4 bolts, washers, lock washers, and 2 nutsto install right onto the rear cross member . Didn’t use the provided bracket either. Took about 15mins I once figured it out.

Received in good shape with a nice finish. Directions were unusual in that they directed you to loosen and remove bolts on the bumper that I found were totally unnecessary steps on the JL. Installation was a breeze. Thank goodness I had watched a YouTube video ahead of time. Price seems to be the standard for these things.

I followed the directions and the install was easy. The "nut plate" comes out with a little persuasion by using a large screw driver or pry bar to push the bumper back from the frame. Very pleased with the hitch.

Seemed very straight forward. Took longer to find my wrenches than it did to install. My 2018 JL didn't have any nut plate so I just used the included hardware. Done!

What’s all this hardware for? Seriously. Just needed 2 bolts and 4 washers.The pits of installing this is loosening a couple of unreachable bolts.Took me an hour all in, in quasi obscurity.

Made in China. Well built and easy to install. But on down side is it is Not American Made.