GRAND ORANGEWindshield Wiper Cowl Vent Grille Panel Hood Compatible with Ford Mustang 1999-2004 2pcs Wiper Cowl Grille Black 3R3Z6302228AAA FO1270102

TOOK my car to a glass shop. They did not install my cowl correctly. So it looked like it did not fit. After watching video of how to install it I realized they did not use the old clips to install so it did not fit well.You have to buy clips as the new one did not come with any. It is very easy to install. Go on line and watch a video.

Their restoration the original piece snapped off prior to getting paint. Super easy to order on Amazon was there the next day. Thanks you guys. Easy install doesn't look aftermarket at all

This part is JUNK. Holding clips are to small, will NOT lock in place, Rubber seal is to small, would NOT lay on windshield as it should. Center section of the 2 parts did not match. A waste of money. Can not return because out of return time which is wrong. If part does not fit, you should have the right to return, not just 30 days. DONT buy until you are ready to use it.

Not quite sure why everybody is having install and fitment issues, it installed on my car just fine and it isn’t even a 99-04. It fits very well on my 1995 mustang gt, looks very good as well. Definitely good value for money. The only drawback I have is where they overlap. It stuck up just a tad, but a little bit of 3m double sided tape alleviated that immediately. It wasn’t even that noticeable to begin with, I was just being anal. You must take into consideration the 1994-2004 mustangs came factory with a once piece cowling, so these cars are not designed for a two piece originally hence why there may be some minor issues when joining the two halves.

It looks good of the clips were not junk. Too small to grab inside the mounting holes. Have to customize the clips and some won't even stay attached. Disappointing but, you get what you pay for.

The two pieces look great! I haven't install them yet. When I do I will add further comments and possibly photos / video.

Like 2 piece design. Looks similar to original 1 piece. Only criticism is I had to add an extra fastener on the front side of the under the hood to get a nice tight seam

Not a good clean fit. Not molded right so sticks up where two pieces come together. Clips are to small and do not clip like should. Had to add tape to get to clip. I’d look into different brand and hope for better fit. Skip this one all together.