Dunlop ECB151 Rubber Feet with Screws, 4/Bag

I lost a few of these over the years and had some screws with washers in place, but am very happy to have all the feet back on as the rubber does help it stay in place. Perfect fit.

Worked great on my Vox wah pedal.

Perfect Match

Replace rubber feet on my sewing machine. Worked, but needed to substitute screws. Minor issue, feet were great.

I replaced two missing feet and two cracked feet on my vintage 1984 Cry Baby. These are real Dunlop feet and the threading on the screws were a perfect fit despite decades between manufacturing dates. Recommended.

I’m so happy that I ordered this product!!! After reading other reviews I decided to take the chance that this is exactly what I’ve been trying to find to replace the feet on my cutting board for years. Sure enough it is perfect! I’ve attached some pictures to give a better idea. I will tell you that another review mentioned they replaced the screws with Stainless Steel ones but in my case I used the washers and screws that were on old board/feet. It only takes a minute to work that washer into the opening before screwing it place but I believe it will help keep the feet from breaking down better as well as keeping the feet secure. The rubber/plastic material they are made with is not that hard rubber/plastic material that you would use on a chair leg to slide across the room but instead the type of rubber that you can press hard on and your fingernail will go into. So perfect for a cutting board on the kitchen counter that you don’t want to slide around when you’re working with a sharp knife. I’m so happy about this product and am ordering more to put on the rest of my cutting boards. A HUGE THANKS to the DUNLOP Company for this product and keeping my fingers safe as well as not scratching my counters!!!

Good rubber feet

They support my music.

It was OK.

Just the job and easy to fit!

The small-head screw can easily pull straight through the soft rubber, leaving it exposed. If whatever you have applied these bumpers-to is sitting on a markable surface, the exposed screws will do a number with scratching. Ideally, there should-have been a molded-in-place hard washer to keep the screw from pulling through.

Purchased these to use as rubber feet for a custom subwoofer build, they work perfect, didn't even have to pre-drill holes.For this price I've been actively trying to find other things to use them for, will definitely purchase again if needed.

My nice end-grain cutting board had developed a little bit of a warp that made it hard to use. These rubber feet are soft enough to provide good grip to my counter, and tall enough to make the warp unnoticeable. Best rubber feet for the price on amazon.